جميع المنتجات

Two-stage low-noise amplifier and filter design. This GPS active antenna is 28dB high gain, GPS active antenna SMA plug, center frequency is 1575.42MHz. GPS satellite signals can be received. DC...

  1 channel relay control card is a relay card that can be used with Arduino or other microcontrollers, where the contacts can be controlled with 5V. It draws a...

    5 V 1200MA USB Output Dc-Dc Boost Converter product stabilizes the input voltage between 2-5 V to 5V. This product, which is very useful with its USB output,...

This expansion board can be used with Arduino UNO - Arduino LENARDO and Arduino Mega 2560. 4 7-segment LED displays controlled by 2 serial connected 74HC595s; 4 smd LED indicators;...

Rotary Potentiometer compatible with Arduino and Raspberry Pi Angular range is 300 degrees with a linear change in value. The resistor value is 10k ohms, perfect for Arduino use. This...

A4988 is a chip designed to control stepper motors with microsteps. Full, half ¼, 1/8 and 1/16 bipolar motor drive modes are available. The motor drive voltage supports up to...

Arduino Ethernet Shield is an ethernet shield prepared and produced over the circuit diagram provided by Arduino. It is fully compatible with the original Arduino Ethernet Shield and all libraries...

With the kit, you can practice SMD component soldering in different cases and improve your soldering skills.

The RC522 RFID Reader Card is a low-power, small-sized card that can read and write tags operating at 13.56 MHz, which is the NFC frequency. It can be used easily...

The SparkFun Level Shifting microSD Breakout is quite similar to the SparkFun microSD Transflash Breakout, but with the level shifting hardware included, this board allows you to use a microSD...

  HC-SR04 Ultrasonic Distance Sensor (Arduino) This ultrasonic sensor, which can measure from 2cm to 400cm with 3mm precision, can be used in various distance reading, radar and robot applications....

Ethernet Shield provides instant internet connection for Arduino projects. The built-in Wiz5100 ethernet controller handles up to four TCP and UDP connections, simply stack it on an Arduino to build...