فاباتيك
الترتيب حسب:
Infrared Receiver Board And Controller
Makeblock Me series modules; It is designed to be easy to connect, easily programmable and Arduino compatible. You can use this infrared receiver module to gain remote control capability in...
Forceup Magnetic Encoder
Magnetic Encoder Encoder system is a system used to determine the speed of motors and the number of revolutions in robotic applications. This electronic card is designed to give motor...
28Db High Gain Active Gps Antenna With Ceramic Wire
Two-stage low-noise amplifier and filter design. This GPS active antenna is 28dB high gain, GPS active antenna SMA plug, center frequency is 1575.42MHz. GPS satellite signals can be received. DC...
Compatible With 5V 1 Channel Relay Board Development Boards
1 channel relay control card is a relay card that can be used with Arduino or other microcontrollers, where the contacts can be controlled with 5V. It draws a...
5 V 1200Ma Usb Output Dc-Dc Boost Converter
5 V 1200MA USB Output Dc-Dc Boost Converter product stabilizes the input voltage between 2-5 V to 5V. This product, which is very useful with its USB output,...
Multi-Function Expansion Card
This expansion board can be used with Arduino UNO - Arduino LENARDO and Arduino Mega 2560. 4 7-segment LED displays controlled by 2 serial connected 74HC595s; 4 smd LED indicators;...
- Rotary Angle Sensor (Rotary Potentiometer)
Rotary Potentiometer compatible with Arduino and Raspberry Pi Angular range is 300 degrees with a linear change in value. The resistor value is 10k ohms, perfect for Arduino use. This...
A4988 Stepper Motor Driver Circuit (Red)
A4988 is a chip designed to control stepper motors with microsteps. Full, half ¼, 1/8 and 1/16 bipolar motor drive modes are available. The motor drive voltage supports up to...
Ethernet Shield (Wiznet W5100)
Arduino Ethernet Shield is an ethernet shield prepared and produced over the circuit diagram provided by Arduino. It is fully compatible with the original Arduino Ethernet Shield and all libraries...
Soldering Practice Card
With the kit, you can practice SMD component soldering in different cases and improve your soldering skills.
Rc522 Rfid Reader 13.56 Mhz
The RC522 RFID Reader Card is a low-power, small-sized card that can read and write tags operating at 13.56 MHz, which is the NFC frequency. It can be used easily...
Level Shifting Microsd Breakout
The SparkFun Level Shifting microSD Breakout is quite similar to the SparkFun microSD Transflash Breakout, but with the level shifting hardware included, this board allows you to use a microSD...