Elektronik

Pololu Dual MC33926 Motor Driver Shield Board is an Arduino compatible shield board built entirely with SMD components based on two Freescale MC33926 ICs. The operating voltage of the MC33926...

Makeblock Me series modules; It is designed to be easy to connect, easily programmable and Arduino compatible. You can use this infrared receiver module to gain remote control capability in...

Magnetic Encoder Encoder system is a system used to determine the speed of motors and the number of revolutions in robotic applications. This electronic card is designed to give motor...

Two-stage low-noise amplifier and filter design. This GPS active antenna is 28dB high gain, GPS active antenna SMA plug, center frequency is 1575.42MHz. GPS satellite signals can be received. DC...

  1 channel relay control card is a relay card that can be used with Arduino or other microcontrollers, where the contacts can be controlled with 5V. It draws a...

    5 V 1200MA USB Output Dc-Dc Boost Converter product stabilizes the input voltage between 2-5 V to 5V. This product, which is very useful with its USB output,...

This expansion board can be used with Arduino UNO - Arduino LENARDO and Arduino Mega 2560. 4 7-segment LED displays controlled by 2 serial connected 74HC595s; 4 smd LED indicators;...

Rotary Potentiometer compatible with Arduino and Raspberry Pi Angular range is 300 degrees with a linear change in value. The resistor value is 10k ohms, perfect for Arduino use. This...

A4988 is a chip designed to control stepper motors with microsteps. Full, half ¼, 1/8 and 1/16 bipolar motor drive modes are available. The motor drive voltage supports up to...

Arduino Ethernet Shield is an ethernet shield prepared and produced over the circuit diagram provided by Arduino. It is fully compatible with the original Arduino Ethernet Shield and all libraries...

With the kit, you can practice SMD component soldering in different cases and improve your soldering skills.

The RC522 RFID Reader Card is a low-power, small-sized card that can read and write tags operating at 13.56 MHz, which is the NFC frequency. It can be used easily...