ملحقات الطاقة
الترتيب حسب:
Reed Relay Module (Compatible with Development Boards)
Reed Relay Module (Compatible with Development Boards) Specifications Comes with fixed bolt hole for easy installation. Working distance: 1.5M ; Working voltage: 3.3V-5V ; Output Type: Digital switching output (0...
Mcore - Mbot Motherboard
Makeblcok mCore is the motherboard that comes on mBot robots. You can use this Arduino UNO-based board not only in your mBot, but also in your own projects. Thanks to...
Button Panel Mount Compatible
Grove - Button (Panel Mount Compatible) Grove button is a module that gives HIGH output from the signal pin when the button is pressed, and LOW output when the button...
10Kohm Sliding Linear/linear Potentiometer
It is a 10k linear potentiometer. ; It has 0.1" header connections for easy connection. ;
Education Ev3 Large Servo Motor
The EV3 large servo motor is a high torque motor that you can operate by sensing 1 degree angles. Thanks to the sensor inside, it can adjust its speed by...
Weight Sensor - 5 Kg
It is a 1kg capacity weight sensor that you can use in your Arduino or Raspberry Pi projects for general purposes. It can use more than one sensor to increase...
Ev3 Touch Sensor
The analog EV3 Touch Sensor is a simple yet highly sensitive tool that detects when the front button is pressed or released and can count single and multiple presses. Students...
Graphics Video Card Fan 75Mm Dc 12V 0.5A 2-Pin Cooling Fan Brushless Fan Graphics Card
FEATURES Power Connector Type2-Pin Voltage12 Volts About this item Model: FD8015U12S Voltage: DC 12V, Current: 0.5A Position Hole Quantity: 3, Step: 39*39*39mm Fan Diameter: 75mm, Cable Length: 167mm, Power Connector:...
- Dust Sensor
Grove - Dust Sensor This Dust Sensor reports air quality by measuring the dust concentration in the environment. The level of Particulate Matter in the Air (PM level) is measured...
16X2 Lcd Module With RGB Backlight
It is suitable for use with Arduino and Raspberry Pi. It is a 16x2 LCD Module with RGB Backlight. Thanks to the RGB Backlight, you can run your screen in...
Shield for Raspberry Pi
By using this module, you can make hardware serial communication (UART) between your Makeblock Orion board and your Raspberry Pi. Features: No need soldering, you can start using it directly;...
4 Digit 7 Segment Display Module
It is a 4-digit display module. The module normally has 12 pins. Thanks to the TM1637 used in this module, the number of pins is reduced to 2. It is...