Sobo Sb-948 Four Outlet Aquarium Air Motor 8W 4X3Lt/min.

Sobo Sb-948 Four Outlet Aquarium Air Motor 8W 4x3LT/Min.

It has an air pressure capacity of 3 liters from 4 outlets per minute.
Voltage: 220V/50Hz
Power:8W

Product Description :

In addition to providing oxygen to the aquarium, it creates a natural ripple in the water.
Energy consumption is very low, only 8 watts.
It has four outputs.
It works continuously and at the same performance.
There is an air outlet speed adjustment button.
Maximum output power is 4 * 3 liters.
It is the leader of its class with its quiet operation.
In aquariums deeper than 50 cm, the bellows will deform in a very short time.
Therefore, large air motors with a single outlet should be used in aquariums deeper than 50 cm.

Instruction manual

It is very easy to install and operate. First, the aquarium above, must be placed in a dry place. If the aquarium has a cover, it can be placed on the aquarium. Particular care should be taken to ensure that it is at the top. Otherwise, the pump may malfunction as water will return to the pump. It is recommended to use a check valve to prevent this situation. After the pump is placed in a suitable place, the pump is ready for use by attaching the hose you will provide suitable for the air motor to the end of the air outlet pipe.

Warnings

Before using the pump, the socket to which it will be plugged should be checked. Faults in the outlet can cause deterioration of the tool.
The socket to which the pump will be installed and the location of the pump are important. It needs to be up and far away in a place that it can not get wet.
If the pump is placed lower than the aquarium, the pump may malfunction due to backwater flow.
Care should be taken to ensure that the pump is in a dry place above the aquarium. It is recommended to use with check valve. It should not be dropped into the aquarium. In the event of downfall it could not be taken out from the water without unplugging. It may cause electric shock.
If the pump falls into water, it should be unplugged and allowed to dry for a few days. It can be operated again after making sure it is dry.
The pump must remain running at all times. It can also work during cleaning as long as the hose is disconnected and care is taken to prevent water from entering. Cleaning is recommended only if the plug has been pulled.
It should definitely not be oiled.
Hose control should be done once a week. For this purpose, some air should be blown from the end of the hose and checked for blockages. If there is a blockage, it should be removed using a special hose brush.